для Cisco Cisco Packet Data Gateway (PDG)
Configuring the SaMOG Gateway
Configuring the System to Perform as a SaMOG Gateway ▀
SaMOG Administration Guide, StarOS Release 19 ▄
127
action priority priority ruledef is_https_ruledef_name charging_action
l4_redirect_charging_action_name
l4_redirect_charging_action_name
Once the configuration for the ruledef, charging action and rulebase are configured based on HTTP or HTTPS
redirection, apply the rest of the configuration as specified below:
redirection, apply the rest of the configuration as specified below:
configure
operator-policy { default | name policy_name }
apn webauth-apn-profile apn_profile_name
exit
apn-profile profile_name
active-charging rulebase rulebase_name
dns { primary | secondary } IPv4_address
ip address pool name pool_name
ip context-name context_name
ip access-group group_name [ in | out ]
exit
call-control-profile profile_name
timeout imsi cache timer_value
subscriber multi-device
authenticate context context_name auth-method { [ eap ] [non-eap] }
end
Configuring and Binding the Interfaces
The interfaces created previously now must be bound to physical ports. Bind the system interfaces by applying the
example configuration below.
example configuration below.
config
port ethernet slot no/port no
no shutdown
bind interface gtp_samog_interface_name gtp_samog_context name
exit
port ethernet slot no/port no