для Cisco Cisco Packet Data Gateway (PDG)
show connectedapps Command
The StarOS show connectedapps command displays information about the current CA configuration.
The following is a sample output of this command:
Current connectedapps controller configuration
CA session userid : iosxr01
CA session password : db1jvk4
CA session name : vm0-1
CA session IP address : 192.168.120.1
CA session ca certificate name : test
RRI mode : S2S & RAS
HA chassis mode : inter
HA network mode : L2
CA session Activation : YES
CA session ID : 28677
CA SRP Status : ACTIVE
CA SRP State : SOCK_ACTIVE
CA session password : db1jvk4
CA session name : vm0-1
CA session IP address : 192.168.120.1
CA session ca certificate name : test
RRI mode : S2S & RAS
HA chassis mode : inter
HA network mode : L2
CA session Activation : YES
CA session ID : 28677
CA SRP Status : ACTIVE
CA SRP State : SOCK_ACTIVE
SRP refers to the Session Redundancy Protocol supported by the StarOS Interchassis Session Recovery (ICSR)
function. For additional information on SRP and ICSR, refer to the VPC-VSM System Administration Guide.
function. For additional information on SRP and ICSR, refer to the VPC-VSM System Administration Guide.
For additional information about this command, see the Exec Mode show Commands chapter in the Command
Line Interface Reference.
Line Interface Reference.
SecGW Administration Guide, StarOS Release 19
32
oneP Communication
show connectedapps Command