Листовка для Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
authenticate service-request ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
1815
signaling
Usage
By default, authentication is not performed for Service Requests. Use this command to enable/disable
authentication and to fine-tune the authentication procedure based on frequency and periods for skipping
authentication and the various types of service. Repeat the commands as needed to configure criteria for all
service types.
authentication and to fine-tune the authentication procedure based on frequency and periods for skipping
authentication and the various types of service. Repeat the commands as needed to configure criteria for all
service types.
Example
The following command configures authentication Service Requests for data service to only occur every 5
minutes:
minutes:
authenticate service-request service-type data periodicity 5