Листовка для Cisco Cisco Packet Data Gateway (PDG)
CSCF Service Configuration Mode Commands
timeout ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
3153
Default: 2000 milliseconds.
invite-expiry sec
: This timer is used by SIP while acting as UA Role and no final response is
received for the INVITE request sent. This timer is applicable for both reliable and unreliable
transport.
transport.
sec
must be an integer from 0 to 2147483646.
Default: 100 seconds (recommended minimum).
t1
msec
: Specifies the time interval (in microseconds) between each retransmission. The interval
doubles after each retransmission, for example: T1, 2T1, 4T2, etc. This timer is applicable only for
unreliable transport.
unreliable transport.
msec
must be an integer from 0 to 2147483646.
Default: 500 milliseconds (recommended minimum).
t2
sec
: This timer is used to control the period for which the request keeps getting retransmitted. This
timer is applicable both for reliable and unreliable transport.
sec
must be an integer from 0 to
2147483646. The recommended minimum value for this parameter is 4 seconds.
Default: 64*T1 (32 seconds)
t4
sec
: This timer is used to control the period for which the final response to non-invite transaction
should be buffered so as to send the buffered response for the retransmitted non-invite request within
that interval. This timer is applicable only for unreliable transport.
that interval. This timer is applicable only for unreliable transport.
sec
must be an integer from 0 to
2147483646.
Default: 5 seconds (recommended minimum).
Usage
Use this command to configure SIP Stack timers and CSCF service specific timers.
Example
The following command sets the SIP d timer to
64
seconds:
timeout sip d 64