Листовка для Cisco Cisco Packet Data Gateway (PDG)
ACL Configuration Mode Commands
redirect css service (for uplink, by ICMP packets) ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
333
source_host_address
The IP address of the source host to filter against expressed in IPv4 dotted-decimal notation.
dest_host_address
The IP address of the destination host to filter against expressed in IPv4 dotted-decimal notation.
dest_address
The IP address(es) to which the packet is to be sent.
This option is used to filter all packets to a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this parameter. The range can
then be configured using the
This option is used to filter all packets to a specific IP address or a group of IP addresses.
When specifying a group of addresses, the initial address is configured using this parameter. The range can
then be configured using the
dest_wildcard
parameter.
dest_wildcard
This option is used in conjunction with the
dest_address
option to specify a group of addresses for which
packets are to be filtered.
The mask must be entered as a complement:
The mask must be entered as a complement:
Zero-bits in this parameter mean that the corresponding bits configured for the
dest_address
parameter must be identical.
One-bits in this parameter mean that the corresponding bits configured for the
dest_address
parameter must be ignored.
Important:
The mask must contain a contiguous set of one-bits from the least significant bit (LSB). Therefore,
allowed masks are 0, 1, 3, 7, 15, 31, 63, 127, and 255. For example, acceptable wildcards are 0.0.0.3, 0.0.0.255, and
0.0.15.255. A wildcard of 0.0.7.15 is not acceptable since the one-bits are not contiguous.
0.0.15.255. A wildcard of 0.0.7.15 is not acceptable since the one-bits are not contiguous.
icmp_type
Specifies that all ICMP packets of a particular type are to be filtered. The type can be an integer value
between 0 and 255.
between 0 and 255.
icmp_code
Specifies that all ICMP packets of a particular code are to be filtered. The type can be an integer value
between 0 and 255.
between 0 and 255.
Usage
Define a rule definition to block ICMP packets which can be used for address resolution and possibly be a
security risk.
The IP redirecting allows flexible controls for pairs of individual hosts or groups by IP masking which allows
the redirecting of entire subnets if necessary.
security risk.
The IP redirecting allows flexible controls for pairs of individual hosts or groups by IP masking which allows
the redirecting of entire subnets if necessary.
Important:
The maximum number of rules that can be configured per ACL varies depending on how the ACL is
to be used. For more information, refer to the Engineering Rules appendix in the System Administration Guide.
Important:
Also note that “redirect” rule definitions are ignored for ACLs applied to specific subscribers or all
subscribers facilitated by a specific context.