Листовка для Cisco Cisco Packet Data Gateway (PDG)
Exec Mode show Commands (M-P)
▀ show multicast-sessions
▄ Cisco ASR 5x00 Command Line Interface Reference
4542
active
Only displays information for multicast sessions that are currently active.
all
If no keywords are specified before
all
, information for all multicast sessions is displayed. If keywords are
specified before
all
, all information is displayed with no further options being allowed.
callid id
Displays multicast session information for the call specified by
id.
The call must be specified as an 8-digit
hexadecimal number.
card-num card_num
The slot number of the processing card by which the subscriber session is processed.
card_num
is a slot
number from 1 through 7 or 10 through 16 on the ASR 5000, or 1 through 4 or 7 through 10 on the
ASR 5500.
ASR 5500.
dormant
Shows information for subscriber sessions that are dormant (not transmitting or receiving data).
flowid id
Displays information for a specific BCMCS flow, defined by
id.
The flow ID must be a hexadecimal
number.
flowid-type [ flow | program ]
Displays information for multicast sessions according to the type of flow.
flow:
Shows all multicast sessions for the flow ID type “flow”.
program:
Shows all multicast sessions for the flow ID type “program”.
mcast-address ipv4_address
Show multicast sessions for a specific multicast address. Must be followed by the IP address of an interface,
using IPv4 dotted-decimal notation.
using IPv4 dotted-decimal notation.
pcf ipv4_address
Displays information for multicast sessions connected via the packet control function, defined by
ipv4_address
. The address must be specified using IPv4 dotted-decimal notation.
pdsn-service svc_name
Displays information for multicast session connected to the packet data service
svc_name.
The packet data
service must have been previously configured and expressed as an alphanumeric string of 1 through 63
characters.
characters.
| { grep grep_options | more }
Pipes (sends) the output of the command to the command specified. You must specify a command to which
the output will be sent.
Please refer to the Regulating a Command’s Output section in the Command Line Interface Overview chapter
for details on the usage of
the output will be sent.
Please refer to the Regulating a Command’s Output section in the Command Line Interface Overview chapter
for details on the usage of
grep
and
more
.