для Cisco Cisco Packet Data Gateway (PDG)
Congestion Control
Configuring Congestion Control ▀
VPC-VSM System Administration Guide, StarOS Release 19 ▄
197
context context_name
{service_configuration_mode}
policy overload redirect address
end
Notes:
Optional: If the congestion control policy action was configured to redirect, then a redirect overload policy must
be configured for the service(s) that are affected.
There are several service configuration modes that you can configure. See the Command Line Interface
Reference for a complete list of modes.
You can set various options for redirection. See the Command Line Interface Reference for more information.
Repeat this configuration example to configure overload policies for additional services configured in the same
context.
Verify the Service Overload Policies
To verify that the service overload policies were properly configured enter the following command in the Exec Mode:
[local]host_name# show service_type name service_name
This command lists the entire service configuration. Verify that the information displayed for the “Overload Policy” is
accurate.
accurate.
Repeat this configuration example to configure additional services in other contexts.
Verify the Congestion Control Configuration
To verify Congestion Control Configuration enter the following show command in the Exec Mode.
[local]host_name# show congestion-control configuration
The following output is a concise listing of all threshold and policy configurations showing multi-level Critical, Major
and Minor threshold parameters:
and Minor threshold parameters:
Congestion-control: enabled
Congestion-control Critical threshold parameters
system cpu utilization: 80%
service control cpu utilization: 80%
system memory utilization: 80%
message queue utilization: 80%
message queue wait time: 10 seconds