для Cisco Cisco Packet Data Gateway (PDG)
Configuring the Evolved Packet Data Gateway
Configuring the System to Perform as an Evolved Packet Data Gateway ▀
ePDG Administration Guide, StarOS Release 17 ▄
91
Configuring the Egress Context and EGTP Service
Use the following configuration example to configure thegress context, the EGTP (Evolved GPRS Tunnel Protocal)
service, the S2b interface and S2b loopback interface to the P-GW, and bind all of the logical interfaces to the physical
Ethernet ports.
service, the S2b interface and S2b loopback interface to the P-GW, and bind all of the logical interfaces to the physical
Ethernet ports.
configure
context <egress_context_name>
interface <s2b_interface_name>
ipv4/ipv6 address <ipv6_address>
exit
interface <s2b_loopback_interface_name>
ipv4/ipv6 address <ipv6_address>
exit
subscriber default
exit
aaa group default
exit
gtpp group default
exit
gtpu-service <gtpu-service-name>
reg-lifetime <seconds>
bind ipv4/ipv6-address <s2bloopbackipv4/ipv6_address>
exit
egtp-service egtp-epdg-egress
interface-type interface-epdg-egress
associate gtpu-service gtpu-epdg-egress
exit
ipv4/ipv6 route <ipv4/ipv6_address/prefix_length> next-hop <ip4/ipv6_address>
interface <s2b_interface_name>
interface <s2b_interface_name>
exit
port ethernet <slot_number/port_number>