Release Note для Cisco Cisco Packet Data Gateway (PDG)
P-GW Changes in Release 15.0
▀ P-GW Enhancements for November 30, 2013
▄ Cisco ASR 5x00 Release Change Reference
394
CSCuh71681 - END_USER_IMSI value received on S6b is reported as
END_USER_E164 onGy,Rf
Feature Changes
IMSI Received on PBU Reported in Both Gy and Rf Accounting Messages
Previous Behavior: For P-GW, the IMSI value received in S6b AAA was being reported in Rf accounting messages
and IMSI received on PBU was reported on Gy accounting messages.
and IMSI received on PBU was reported on Gy accounting messages.
New Behavior: For P-GW, the IMSI value received in S6b AAA is ignored and IMSI received on PBU is reported in
both Gy and Rf accounting messages.
both Gy and Rf accounting messages.
Customer Impact: None.
CSCuh73686, CSCul49747 - P-GW: Modification of ‘timeout bearer-inactivty’
CLI to ignore default bearer
Feature Changes
Timeout Bearer Inactivity Feature
Previous Behavior: The timeout bearer-inactivity CLI monitored all bearers on the PDN for inactivity. If the default
bearer timed out unexpectedly, it caused the session to be torn down and the user was disconnected. This feature also
looked at both uplink and downlink data.
bearer timed out unexpectedly, it caused the session to be torn down and the user was disconnected. This feature also
looked at both uplink and downlink data.
New Behavior: The bearer inactivity timer can now be configured to exclude default bearer/primary bearer from
monitoring bearer inactivity. In addition, this feature now has the option to look at either uplink or downlink data.
monitoring bearer inactivity. In addition, this feature now has the option to look at either uplink or downlink data.
Command Changes
timeout bearer-inactivity
This command configures the bearer inactivity timer and the threshold value of the traffic through an APN.
New keywords have been added so the threshold value can now be configured for monitoring traffic at various levels.
The bearer inactivity timer can also be configured to exclude default bearer/primary bearer from monitoring bearer
inactivity.
The bearer inactivity timer can also be configured to exclude default bearer/primary bearer from monitoring bearer
inactivity.
config
context context_name
apn apn_name
timeout bearer-inactivity seconds volume-threshold { downlink bytes | total bytes
| uplink bytes }
| uplink bytes }
timeout bearer-inactivity exclude-default-bearer