Release Note для Cisco Cisco Packet Data Gateway (PDG)
P-GW Changes in Release 15.0
▀ P-GW Enhancements for September 30, 2013
▄ Cisco ASR 5x00 Release Change Reference
416
session trace random
The following new command has been added to the Exec Mode to enable or disable the subscriber session trace
functionality based on a the random trace on the network element. If enabled, the subscriber selection will be based on
random logic on all instance of session on a specified UMTS/EPS network element. It also clears/resets the statistics
collected for subscriber session trace on a system.
functionality based on a the random trace on the network element. If enabled, the subscriber selection will be based on
random logic on all instance of session on a specified UMTS/EPS network element. It also clears/resets the statistics
collected for subscriber session trace on a system.
[ no ] session trace random random_num network-element { ggsn | pgw } [ interface { all |
interface } ] [ collection-entity ip_address ]
interface } ] [ collection-entity ip_address ]
session trace signaling
The following new command has been added to the Exec Mode to enable or disable the subscriber session trace
functionality based on signaling information on one or all instance of session on a specified UMTS/EPS network
element. It also clears/resets the statistics collected for subscriber session trace on a system.
functionality based on signaling information on one or all instance of session on a specified UMTS/EPS network
element. It also clears/resets the statistics collected for subscriber session trace on a system.
[ no ] session trace signaling network-element { ggsn | pgw }
show peer-profile
The following new command displays configuration of the specified peer profile.
show peer-profile { all | full { all | name profile_name } | name profile_name }
Modified P-GW Commands
This section identifies P-GW commands modified in release 15.0.
associate
The new keyword
peer-map
associates an LTE Policy peer map with a P-GW service.
configure
context context_name
pgw-service svc_name
associate peer-map map_name
no associate peer-map
end
associate
The new keyword
qci-qos-mapping
has been added to configure DSCP marking of the outer header of a GTP-U
tunnel packet based on a QCI table. DSCP marking shall be supported on a per APN basis.
configure
context context_name
apn apn_name