Примечания к выпуску для Cisco Cisco Aironet 350 Wireless LAN Client Adapter
14
Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 1.1
OL-5800-01
Installing or Upgrading Client Adapter Software
Figure 9
Setup Status Window
The installation process begins, and you are notified as each software component is installed.
Step 26
When a message appears indicating that your computer needs to be rebooted, click OK and allow your
computer to restart.
computer to restart.
Step 27
If you are using a PI21AG card, follow the instructions in
Chapter 3
of the Cisco Aironet 802.11a/b/g
Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide to insert the
PCI card.
PCI card.
Step 28
If the Windows Found New Hardware Wizard appears after your computer reboots, click Next, allow the
wizard to install the software for the client adapter, and click Finish.
wizard to install the software for the client adapter, and click Finish.
Step 29
If your network setup does not include a DHCP server and you plan to use TCP/IP, follow these steps
for your operating system.
for your operating system.
•
Windows 2000
a.
Double-click My Computer, Control Panel, and Network and Dial-up Connections.
b.
Right-click Local Area Connection x (where x represents the number of the connection).
c.
Click Properties.
d.
In the Components Checked Are Used by This Connection field, click Internet Protocol
(TCP/IP) and Properties.
(TCP/IP) and Properties.
e.
Choose Use the following IP address and enter the IP address, subnet mask, and default
gateway address of your computer (which can be obtained from your system administrator).
gateway address of your computer (which can be obtained from your system administrator).
f.
Click OK to close each open window.