для Cisco Cisco Catalyst Blade Switch 3020 for HP
10
Cisco Software Activation Document for HP
OL-12769-01
Software Activation
•
Removing the software license information from the switch—Enter the license clear feature-name
switch switch-num privileged EXEC command.
switch switch-num privileged EXEC command.
–
Use the feature-name parameter to specify the feature set to be removed.
–
Use the switch-num parameter to specify the stack member.
•
Recovering from a corrupt license
–
If you use Cisco License Manager, reinstall the license.
–
If you use an application other than Cisco License Manager, re-install an uncorrupted version
of the license on the switch.
of the license on the switch.
•
Displaying software license information—See the
.
Example
After you get a software license from the Cisco Product License Registration Portal, this example shows
how to use TFTP to install the license on a switch:
how to use TFTP to install the license on a switch:
Switch# copy tftp flash:
Address or name of remote host [ ]? 10.0.0.1
Source filename [ ]? license_name-ips
Destination filename [license_name-ips]?
Accessing tftp://172.20.244.138/r1fs-ips...
Loading license_name-ips from 172.20.244.138 (via GigabitEthernet1/0/1): !
[OK - 1161 bytes]
1161 bytes copied in 0.059 secs (19678 bytes/sec)
If you enter the show flash: privileged EXEC command, the command output shows that the software
license file is in the flash memory but that the feature set is not enabled.
license file is in the flash memory but that the feature set is not enabled.
Switch# license install flash: license_name-ips
Installing licenses from "flash: license_name-ips "
Installing...Feature:ipservices...Successful:Supported
1/1 licenses were successfully installed
0/1 licenses were existing licenses
0/1 licenses were failed to install
Switch#
19:46:56: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Next reboot level = ipservices
and License = ipservices
After installing the license for the IP services feature set on the switch, you can enter the show version
privileged EXEC command to display the software license information. In this example, the switch is
currently running the IP base feature set.
privileged EXEC command to display the software license information. In this example, the switch is
currently running the IP base feature set.
Switch# show version
<output truncated>
License Level: ipbase Type: Permanent
Next reboot license Level: ipservices
<output truncated>