Руководство По Установке для Cisco Cisco Virtual Topology System 2.3
© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 28 of 28
interface nve1
no shutdown
source-interface loopback0
host-reachability protocol bgp
interface Ethernet1/21
description "Compute 1 second connection for ESI with Eth2"
switchport
switchport mode trunk
switchport trunk allowed vlan none
channel-group 30
interface Ethernet2/2
description "CONNECTED WITH SPINE"
evpn multihoming core-tracking <<<Just
add this under the Interface connected with Spine>>>
ip address 17.1.1.2/24
ip router ospf 100 area 0.0.0.0
ip pim sparse-mode
no shutdown
Server/Host Configuration
After your BGP sessions are established, use the below command to see if ESI is up.
show nve etherenet-segment detail
ESI: 03.<aa:bb:cc:dd:ee:ff><00:00:2d>,
Parent interface: port-channel30,
ES State: Up
Port-channel state: Up
NVE Interface: nve1
NVE State: Up
Host Learning Mode: Control-Plane
Active Vlans: --
DF Vlans: --
Active VNIs: --
Number of ES members: 2
My ordinal: 1
DF timer start time: 00:00:00
Config State: config-applied
DF List: 9.1.1.1 10.1.1.1
ES route added to L2RIB: True
EAD routes added to L2RIB: True
ESI: 03.<aa:bb:cc:dd:ee:ff><00:00:2d>,
Parent interface: port-channel30,
ES State: Up
Port-channel state: Up
NVE Interface: nve1
NVE State: Up
Host Learning Mode: Control-Plane
Active Vlans: --
DF Vlans: --
Active VNIs: --
Number of ES members: 2
My ordinal: 1
DF timer start time: 00:00:00
Config State: config-applied
DF List: 9.1.1.1 10.1.1.1
ES route added to L2RIB: True
EAD routes added to L2RIB: True