Руководство По Установке для Cisco Cisco Prime Network Registrar Jumpstart 8.2

There are several layers of processing involved in running the Cisco Prime Network Registrar 
application. Each layer has choices it can make about what to do when it is first powered up after power 
failures.

You can configure the Cisco Prime Network Registrar to start automatically when power is restored to 
the Jumpstart.

The two places where you have to change the configurations to make this possible are:

UCS Hardware—The UCS hardware has to be configured to power up the ESXi hypervisor when 
power is restored.

ESXi Hypervisor—The ESXi hypervisor has to be configured to power up the Cisco Prime Network 
Registrar virtual appliance when power is restored to the ESXi hypervisor layer.

To configure the UCS Hardware to automatically power up the ESXi hypervisor:

Connect a browser to the CIMC UCS Management Console and log into the console. 

In the Server tab on the left pane, select the Power Policies link. 

Select Power On from the Power Restore Policy drop-down list in the Power Restore Policy area in the 
right pane. 

If you want, you can enter a delay value in the Power Delay Value field.

Click Save Changes to save the updates.

To configure the ESXi hypervisor to automatically power up the Cisco Prime Network Registrar virtual 
appliance when power is restored to the ESXi hypervisor layer, see the “Configuring the Virtual 
Appliance to Automatically Power Up” section of Cisco Prime Network Registrar 8.2 Installation 
Guide.