Руководство Разработчика для Cisco Cisco Prime Optical 9.8
Cisco Prime Optical 9.8 GateWay/CORBA Programmer Reference Guide
OL-29218-01
560
4.7.1.1 createAndActivateFDFr
Synopsis
Description
The NMS invokes the createAndActivateFDFr service to request the EMS to create and activate
a pseudowire with the parameters specified in the method.
a pseudowire with the parameters specified in the method.
Parameters
• FDFrCreateData_T createData—Describes the structure of the FDFr to be created. Unless
specified otherwise, connectionless parameter settings are on a best-effort basis.
• ConnectivityRequirement_T connectivityRequirement—For a connectivity-aware EMS, this
parameter identifies the requested operation mode if not all FPs have potential connectivity
to one another. If the EMS is not connectivity-aware, ignore this parameter.
to one another. If the EMS is not connectivity-aware, ignore this parameter.
• NamingAttributesList_T aEnd—The source CTP/EFP based on a CPTP. The CTP name
implicitly provides the AC type and VLAN configuration. Pseudowires always have only one
aEnd point. The name of each aEnd must be in the following format:
aEnd point. The name of each aEnd must be in the following format:
name="EMS";value="CompanyName/EMSname"
name="ManagedElement";value="name"
name="PTP";value="/rack/shelf/slot/ppm_holder=m/port=n"
name="CTP";value="CTP Name"
For PTSA_GE endpoints, the PTP name must be in the following format:
name="PTP";value="/remote_unit=1/shelf=1/slot=36/ppm_holder=9/port=1"
Slot 36 is mapped to the PTSA_GE remote equipment.