Руководство По Установке для Cisco Dual Tier Addressable Stretch Tap
Chapter 3 Installing a Twisted Pair Module
38
590212 Rev G
2 Using a 3/8-in. wrench, remove the four faceplate bolts on the Twisted Pair
module.
3 Attach the Twisted Pair module to the tap faceplate, making sure that the
electrical connections on the back of the module are seated firmly to the
faceplate.
Note: If there is any doubt that the module is seated firmly, remove the module
and inspect the electrical connections. If any electrical connections are bent,
straighten them out and reattach the module.
faceplate.
Note: If there is any doubt that the module is seated firmly, remove the module
and inspect the electrical connections. If any electrical connections are bent,
straighten them out and reattach the module.
4 Refer to the following illustration and perform these steps:
Using a 3/8-in. wrench, torque the two bolts from 50 in-lb to 60 in-lb (5.6 N-
m to 6.8 N-m).
m to 6.8 N-m).