Руководство По Установке для Cisco Cisco D9804 Multiple Transport Receiver
Viewing System Information
78-4042990-01 Rev B
129
Setting up Ethernet Ports
Proceed as follows to configure the Ethernet ports:
1 From the user interface of the D9804 MTR, click the System tab and then
1 From the user interface of the D9804 MTR, click the System tab and then
Ethernet icon from the sub-page.
2 Define the Port Name.
Type a description or name, up to 20 alphanumeric characters in length, for the
Ethernet port.
Ethernet port.
3 Set the IP Address and Mask information. It is the IP Address and Subnet Mask
to the receiver for its participation in a Network environment.
The IP address contains up to 12 characters and the Mask contains up to two
characters long.
Note: Changing the IP address will disconnect you from the current browser
session.
The IP address contains up to 12 characters and the Mask contains up to two
characters long.
Note: Changing the IP address will disconnect you from the current browser
session.
4 Set the Gateway address on the network, used to expose the receiver to a WAN.
The IP Address, Mask, and Gateway address should be changed together (e.g. as
a group). The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size of
your network.
a group). The following table shows the most commonly used Subnet mask
values to enter for a chosen IP address mask, which will depend on the size of
your network.
Mask
Subnet Mask
8
255.0.0.0
16
255.255.0.0
24
255.255.255.0
5 The MAC field displays the MAC address of the receiver. The field is set at the
factory and is for information purposes only.
6 Click Apply.