Листовка для Cisco Cisco D9859 Advanced Receiver Transcoder
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Tuning subtree of the CISCO-DMN-DSG-ROOT MIB
Configuration Example of the Symbol Rate of the RF1 Channel
Configuration Example with Validation
Illustration
Conclusion
Introduction
This document describes an example on how to configure a Cisco D9859 (used as example)
receiver using Simple Network Monitoring Protocol (SNMP).
receiver using Simple Network Monitoring Protocol (SNMP).
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
The Net-SNMP application (snmpwalk, snmpget, snmpset, snmptranslate)
●
One or more Cisco D9859 receivers (for this example)
●
Components Used
The information in this document is based on Cisco D9859 on the release v1.51 using the
D9859_Feature_MIB_V1.50.
D9859_Feature_MIB_V1.50.
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
Background Information
This example focuses on changing the Symbol Rate of the RF1 Input. The same commands can
be used to change other parameters of the configuration. Object IDentifiers (OIDs) were obtained
by browsing the Cisco D9859_Feature_MIB available on Cisco.com at
be used to change other parameters of the configuration. Object IDentifiers (OIDs) were obtained
by browsing the Cisco D9859_Feature_MIB available on Cisco.com at