Руководство По Установке для Cisco 1 GHz Surge-Gap Reverse Window Taps
Chapter 2 Installing the Tap/Passive
Installing the Tap/Passive on a Strand
The strand-mounted configuration has the feeder cable entering one side of the unit
and exiting the other side. The unit has one strand clamp with a strand clamp bolt
and uses a standard cable strand for mounting.
To Install the Tap/Passive on a Strand
Follow these steps to install tap/passive on a strand.
1. Using a 3/8-in. wrench, loosen the strand clamp bolt.
2. Attach the tap/passive to the strand making sure that the strand enters the
1. Using a 3/8-in. wrench, loosen the strand clamp bolt.
2. Attach the tap/passive to the strand making sure that the strand enters the
strand clamp.
3. Secure the strand clamp to the strand by tightening the strand clamp bolt with a
3/8-in. wrench from 30 in-lb to 40 in-lb (3.4 Nm to 4.5 Nm).
4. Using a 3/16-in. hex-head driver or 3/16-in. straight blade screwdriver, loosen
the two seizure screws inside the housing.
14
OL-31976-01