Руководство По Установке для Cisco Headend System Release 2.7
Chapter 6 Post-Installation Tasks
62
78-4036705-01 Rev D
Connect to the Monitor and Keyboard
If you have a monitor and keyboard to install, you should set them up now.
Complete the following steps to connect a monitor and keyboard to your server and
to set the system environment to use the monitor and keyboard for output and
input.
Complete the following steps to connect a monitor and keyboard to your server and
to set the system environment to use the monitor and keyboard for output and
input.
Important: Only perform this procedure if you are attaching a keyboard and
monitor to your DTACS Server.
monitor to your DTACS Server.
Note: You should still have access to the DTACS Server via the ILOM port and be
logged in as root user.
1 Attach the monitor’s video cable to the graphics card’s video port, and then
logged in as root user.
1 Attach the monitor’s video cable to the graphics card’s video port, and then
tighten the thumbscrews to secure the connection.
2 Connect the monitor’s power cord to an AC outlet.
3 Connect the USB keyboard cable to one USB port and the USB mouse cable to the
3 Connect the USB keyboard cable to one USB port and the USB mouse cable to the
other USB port on the DTACS Server server back panel.
4 If the ILOM prompt () does not appear, type #. and press Enter.
5 At the ILOM prompt, type set /HOST send_break_action=break and press
5 At the ILOM prompt, type set /HOST send_break_action=break and press
Enter.
6 Type start /SP/console -f and press Enter.
7 When prompted, type r (for reset) and press Enter.
8 Does the OK prompt appear?
7 When prompted, type r (for reset) and press Enter.
8 Does the OK prompt appear?
If yes, go to step 9.
If no, type set /HOST send_break_action=break and press Enter to send
another break. The OK prompt appears. Go to step 9.
another break. The OK prompt appears. Go to step 9.
9 At the OK prompt, type setenv input-device keyboard and press Enter. The
input device is now set to the keyboard.
10 At the OK prompt, type setenv output-device screen and press Enter. The
output device is now set to the screen (monitor).
11 Type shutdown -y -g0 -i6 and press Enter. The system reboots, and the monitor
and keyboard are now the active input and output devices for the server.
12 Login as root user.