Руководство По Установке для Cisco Headend Digital Broadband Delivery System
Create an xOD Package
78-4004034-01 Rev C
43
Create an xOD Package
Introduction
After you set up the BFS, you must define an xOD package. A package consists of
one or more services that are available only to specifically authorized subscribers.
For example, because secure services are encrypted, the only way for a subscriber to
For example, because secure services are encrypted, the only way for a subscriber to
access a secure service is for you to place the service in a package. Then, you can
authorize the subscriber’s DHCT to receive that package. When you authorize the
DHCT to receive the package, you enable the DHCT to decrypt the service so that
the subscriber can view it.
Important: If you have an existing package that you want to use for xOD, you do not
Important: If you have an existing package that you want to use for xOD, you do not
need to complete this procedure. Instead, go to Determining the xOD Package EID
(on page 45).
Creating an xOD Service Package
Complete these steps to define an xOD service package.
Note: If you have an existing package that you want to use for an xOD service, you
Note: If you have an existing package that you want to use for an xOD service, you
do not need to complete this procedure for that service. Instead, you can go to
Determining the xOD Package EID, later in this section.
1 On the DNCS Administrative Console, click the DNCS tab if it is not already in
1 On the DNCS Administrative Console, click the DNCS tab if it is not already in
the forefront.
2 Click the System Provisioning tab if it is not already in the forefront.