Руководство По Установке для Cisco Headend System Release 2.5
Chapter 2 SR 5.0 Pre-Upgrade Procedures
26
4042225 Rev A
2 From a root xterm window on each server that you are upgrading, type the
following command and press Enter to stop the Solaris Volume Manager.
svcadm -v disable -s volfs
3 Type the following command and press Enter to check for the presence of the
DVD drive and to record the disk from the Logical Node entry.
rmformat -l
Note: The "l" in the command is a lowercase L.
4 Record the disk entry in the space provided. __________
5 Insert the system release installation DVD into the CD-ROM drive of the server.
6 Type the following command and press Enter to create the mount point for the
5 Insert the system release installation DVD into the CD-ROM drive of the server.
6 Type the following command and press Enter to create the mount point for the
DVD.
mkdir -p /cdrom/cdrom
7
Type the following command and press Enter to mount the DVD.
Important: Although the rmformat command shows the device as
/dev/rdsk/c0t0d0s2, use /dev/dsk/c0t0d0s0 for the mount command. You may
need to replace "c0t0" depending on your hardware. For example, if rmformat
shows the logical node as /dev/rdsk/c0t1d0s0, you would use
/dev/dsk/c0t1d0s0 with the mount command.
Important: Although the rmformat command shows the device as
/dev/rdsk/c0t0d0s2, use /dev/dsk/c0t0d0s0 for the mount command. You may
need to replace "c0t0" depending on your hardware. For example, if rmformat
shows the logical node as /dev/rdsk/c0t1d0s0, you would use
/dev/dsk/c0t1d0s0 with the mount command.
mount –F hsfs /dev/dsk/[/dev/dsk/[disk]] /cdrom/cdrom
Note: Substitute the appropriate device syntax for c#t#d#s0 from the rmformat
–l output you recorded in step 4.
Example:
–l output you recorded in step 4.
Example:
mount –F hsfs /dev/dsk/c0t0d0s0 /cdrom/cdrom
Troubleshooting Tip: If /cdrom/cdrom is busy, make sure the mount point is
not already in use or that you are not already in the /cdrom directory. You
cannot mount to cdrom if you are in the directory.
not already in use or that you are not already in the /cdrom directory. You
cannot mount to cdrom if you are in the directory.
8
Type the following command and press Enter to verify that the OS.flar file can be
read.
read.
dd if=/cdrom/cdrom/sai/flash_archives/OS.flar of=/dev/null
Notes:
This command may take 15 to 20 minutes to complete.
If this command fails, contact Cisco Services for assistance.