Руководство По Установке для Cisco Prisma II bdr Dig Rev 2 1 Dual Mux Sys for High Density Installations
78-741939-01 Rev C
Installing the Enhanced Digital Reverse Modules in the Node
2-29
Status Monitoring Connection,
Continued
4. Connect the cable that is attached to the Rx (receiver) connector on the
status monitor module to the J8 connector location on the J8 jumper board.
5. Connect the cable that is attached to the Tx (transmitter) connector on the
status monitor module to the Status Monitoring Input on the 2:1 enhanced
multiplexing digital module using the status monitoring coax cable
provided with the enhanced digital reverse modules.
6. Connect the power cable that is attached to the status monitor module to the
Status Monitor connection on the RF launch amplifier.
Results:
Results:
•
The Status Indicator on the status monitor module illuminates to indicate
the unit has power.
•
The Status Indicator flickers when the status monitor module is
communicating with the status monitoring system.
7. Route all cables to ensure they are not damaged when the housing is closed.