Руководство По Установке для Cisco Headend System Release 2.7
Logging on to the RNCS Servers
78-4021167-01 Rev D
7
d To set the Network Mask for the port, type
set /SP/network pendingipnetmask=<xxx.xxx.xxx.x> and then press Enter.
Note: Replace <xxx.xxx.xxx.x> with the Network Mask for the serial
management port.
e To configure the port to use SSH, type
set /SP/services/ssh state=enabled and then press Enter.
f To enable the port, type
set /SP/network state=enabled and then press Enter.
g To display the current port settings, type
show /SP/network and then press Enter.
h If any of the settings are not correct, retype the necessary command to set the
parameter to the proper value, and then repeat step 5g.
i To commit and implement the new port settings, type
set /SP/network commitpending=true and then press Enter.
j To display the current port settings, and to verify that the settings are
implemented, type
show /SP/network and then press Enter.
Example: Output should look similar to the following example:
commitpending = (Cannot show property)
commitpending = (Cannot show property)
dhcp_server_ip = none
ipaddress = 10.90.177.23
ipdiscovery = static
ipgateway = 10.90.177.1
ipnetmask = 255.255.255.0
macaddress = 00:14:4F:EB:4C:E1
pendingipaddress = 10.90.177.23
pendingipdiscovery = static
pendingipgateway = 10.90.177.1
pendingipnetmask = 255.255.255.0
state = enabled
k To enable the HOST_LAST_POWER_STATE parameter of the port, type
set /SP/policy HOST_LAST_POWER_STATE=enabled and then press
Enter.
l Type show /SP/policy HOST_LAST_POWER_STATE and then press Enter
to confirm that the HOST_LAST_POWER_STATE parameter was set
correctly.
Note: The system should display HOST_LAST_POWER_STATE = enabled.
6 Connect an Ethernet cable from the network management port on the back of the
Sun Netra T5220 server to the appropriate network hub, switch, or router.
7 Verify that the port is functional by opening an SSH session to the IP address of
the port. The ILOM login prompt should appear.
8 Log on using root as the username and the appropriate password.
9 Type exit and then press Enter to log out from the serial management port.
9 Type exit and then press Enter to log out from the serial management port.