Руководство По Установке для Cisco Headend System Release 2.7
Chapter 1 Initial Installation of RNCS Software
8
4022447 Rev B
Step Procedure
Reference
Parameters Required
–
Add video QAMs
Adding Video QAMs
(on page 52)
(on page 52)
Headend name associated with the QAM
QAM name
QAM MAC address
QAM IP address
QAM subnet mask
QAM modulation type
Default gateway (if used)
QAM administrative state (online or offline)
Allow SI
QAM input port (type)
Modulation type
Output TSID
QAM center channel frequency (in MHz)
Hubs associated with this QAM
–
Connect RNCS video
sources to RNCS
video QAMs
sources to RNCS
video QAMs
MPEG source output port number
MPEG source transport stream ID
MPEG source transport protocol
MPEG source output card MAC address
MPEG source output card IP address
MPEG source output card subnet mask
Headend name where this QAM resides
Device type (QAM)
Port number on QAM that connects to
MPEG source
MPEG source
–
Create BFS source
definitions
definitions
First part of the session ID: Use the RNCS
MAC address
MAC address
Second part of the session ID: Use the
original source ID
original source ID
–
Start RNCS sources
Starting the RNCS
Sources (on page 55)
Sources (on page 55)
N/A
9
Start the RNCS
Starting the RNCS
(on page 56)
(on page 56)
N/A