Руководство По Установке для Cisco Headend System Release 2.7
Upgrade the RNCS Software
4012763 Rev B
33
22 Type lustatus and then press Enter. The system displays the status of the
LiveUpgrade boot environment.
Example: You should see results similar to this example:
BE_name Complete Active ActiveOnReboot CopyStatus
------------------------------------------------------------------------
1.0.0.x yes yes yes -
LIONN_V1.0.0.x yes no no -
Notes:
Example: You should see results similar to this example:
BE_name Complete Active ActiveOnReboot CopyStatus
------------------------------------------------------------------------
1.0.0.x yes yes yes -
LIONN_V1.0.0.x yes no no -
Notes:
The version of LIONN software associated with the 1.0.0.x designation refers
to the version of the SAIlionn package currently installed on the RNCS
server.
The version of LIONN software associated with the upgrade
(LIONN_V1.0.0.x) is the same as what is listed on the LIONN DVD.
This example shows that the new version of RNCS software is not yet active.
23 Type luactivate LIONN_V1.0.0.x and then press Enter.
Note: V1.0.0.x refers to the version of the RNCS DVD.
Result: The system activates the new version of RNCS software and displays the
Result: The system activates the new version of RNCS software and displays the
following message:
*************************************************************************
The target boot environment has been activated. It will be used when you
*************************************************************************
The target boot environment has been activated. It will be used when you
reboot.
NOTE: You must use either init or shutdown when you reboot. If you do not
use one of these commands, the system will not boot using the target BE.
*************************************************************************
In case of a failure while booting to the target BE, the following process
needs to be followed to fallback to the currently working boot environment:
1. Enter the PROM monitor (ok prompt).
2. Change the boot device back to the original boot environment by typing:
setenv boot-device disk:a
3. Boot to the original boot environment by typing:
*************************************************************************
In case of a failure while booting to the target BE, the following process
needs to be followed to fallback to the currently working boot environment:
1. Enter the PROM monitor (ok prompt).
2. Change the boot device back to the original boot environment by typing:
setenv boot-device disk:a
3. Boot to the original boot environment by typing:
boot
*************************************************************************
Activation of boot environment <LIONN_V1.0.0.x> successful.
*************************************************************************
Activation of boot environment <LIONN_V1.0.0.x> successful.