Руководство По Установке для Cisco Headend System Release 2.7

 

4038415 Rev A 

75 

 

The dhctStatus Utility usually runs from cron and will start at its scheduled time. 

 

If the signonCount utility was running prior to the upgrade, follow these steps to 
restart the utility.  If you do not want to start the signonCount utility at this time, 
skip this procedure and go to the next procedure in this chapter. 
1  Type the following command and press Enter. The signonCount process starts 

and begins displaying the set-top sign-on status. 

2  Press the Ctrl and C keys simultaneously to stop the terminal output. 
3  Type the following command and press Enter to monitor the signonCount utility 

status. The terminal displays the last 10 lines in the output file, as well as any 
new entries made to the output file. 

4  Press the Ctrl and C keys simultaneously to terminate the tail process. 

 

1  To restart the cmd2000 utility, type the following commands and press Enter 

after each command. 

 

 

2  Type the following command and press Enter to verify that the cmd2000 services 

have been enabled. The system displays both cmd2000 services as online. 

Note:  If the cmd2000 services show a status of Maintenance, or if they are not 
online, call Cisco Services for assistance.