Руководство По Установке для Cisco Headend System Release 3.2
Check BFS QAM Sessions
4038415 Rev A
83
12 After the indicator for the bfsServer process has turned green, highlight the osm
process.
13 Click Process and then select Start Process. In a few minutes, the indicator for
the osm process changes from red to green.
14 Press the Options button on the front panel of the BFS QAM until the Session
Count total appears.
15 Wait about 10 minutes for the system to rebuild the sessions.
16 Does the Session Count total now equal the number of sessions you recorded in
16 Does the Session Count total now equal the number of sessions you recorded in
Check and Record Sessions (on page 26)?
If yes, go to the next procedure in this chapter. The system recovered all of
the BFS sessions.
the BFS sessions.
If no, call Cisco Services for assistance.
Verify That BFS Sessions Rebuild
1 From the DNCS tab of the DNCS Administrative Console, click Utilities.
2 Click Session List. The Session List window opens.
3 Highlight BFS QAM and click Display. The BFS QAM Session Summary
2 Click Session List. The Session List window opens.
3 Highlight BFS QAM and click Display. The BFS QAM Session Summary
window opens.
Note: Click Rows per page and select a number of rows that will display all BFS
sessions.
Note: Click Rows per page and select a number of rows that will display all BFS
sessions.
4 Click into the top box on the left side of the BFS QAM Session Summary
window. A check mark appears next to each session.
5 Click Tear Down. A confirmation message appears.
6 Click OK. The system tears down the BFS sessions.
7 As the sessions tear down, verify the following:
6 Click OK. The system tears down the BFS sessions.
7 As the sessions tear down, verify the following:
Session count on the BFS QAM goes to 0
Session State on the UI indicates Complete
Note: You can clear completed sessions with the clearDbSessions -c
command.
Note: You can clear completed sessions with the clearDbSessions -c
command.
Session count rebuilds on the BFS as the sessions are rebuilt
8 Type the following commands and press Enter to verify the BFS QAM session
count.
a
a
auditQam –query <BFS QAM IP address> <port #>
Notes: Replace <port #> with the following port numbers on the BFS QAM:
–
–
CAQAM — 2
–
MQAM — can be 1 through 4
–
GQAM — can be 1 through 16
b
/opt/solHmux64/vpStatus –d /dev/Hmux0 –P 0