Примечания к выпуску для Cisco Headend System Release 2.7
SR 3.8 at a Glance
4019365 Rev B
13
Known Issues
Introduction
This chapter lists the CRs that were found while testing this software product.
Efforts to address these issues are ongoing in the Cisco laboratories.
Efforts to address these issues are ongoing in the Cisco laboratories.
CR 74881: DNCS Saves Values When User Presses Enter in Text Box in Session Data
In the Configure Session Data user interface, if a user enters a UDP port number for
a table-based QAM and then presses Enter, the DNCS automatically saves the
information.
a table-based QAM and then presses Enter, the DNCS automatically saves the
information.
CR 74887: Service Group ID Does Not Accept Valid Values in the Service Group WUI
In the Service Group Data user interface, the DNCS does not accept 08 or 09 as valid
values for the Service Group ID field. However, it does accept other values with a
leading zero (01, 02, 03, and so on). This prevents users from entering valid service
group numbers.
values for the Service Group ID field. However, it does accept other values with a
leading zero (01, 02, 03, and so on). This prevents users from entering valid service
group numbers.
CR 75012: Netcrypt WUI Throws Exception When User Clicks on Update Netcrypt
The DNCS may throw an exception if a user follows a series of commands through
the Netcrypt user interface. For this to occur, the user must open the Netcrypt List
user interface, select a Netcrypt and click Edit, and then click Multicast Sessions.
After this window has been open for several minutes, click Update Netcrypt. The
DNCS may throw an exception if this occurs.
the Netcrypt user interface. For this to occur, the user must open the Netcrypt List
user interface, select a Netcrypt and click Edit, and then click Multicast Sessions.
After this window has been open for several minutes, click Update Netcrypt. The
DNCS may throw an exception if this occurs.
CR 79907: Set-Top May Not Boot When User Changes DCM Mode for a QPSK Modulator
If the user changes the DCM mode for a QPSK modulator, then the set-top may
search indefinitely for Uncfg, BFS, SAM, and IPG. If this occurs, you can bounce the
DNCS to clear the issue.
search indefinitely for Uncfg, BFS, SAM, and IPG. If this occurs, you can bounce the
DNCS to clear the issue.
CR 82770: SAM Service Must Be Refreshed to See Newly Created Service
When the user creates and saves a new SAM service, the service does not
automatically appear in the SAM service user interface. The user must refresh the
screen to see the new SAM service.
automatically appear in the SAM service user interface. The user must refresh the
screen to see the new SAM service.
CR 84145: Channels, Sources and Sessions Report Doesn't Allow Users to Toggle Correctly
The Channels, Sources, and Sessions Report in Report Writer may not allow users to
toggle properly between channels.
toggle properly between channels.