Руководство По Установке для Cisco Model 6109 6 MHz Off-Air Reference (NTSC)
Chapter 3 USRM Web Interface
182
78-4021139-01 Rev D
ResourceManager - QAM - Data Gbe Ports Page (GQAM Only)
The following illustration shows the ResourceManager - GQAM - Data Gbe Ports
page.
Note: This page is for GQAMs only.
Note: This page is for GQAMs only.
Parameters
The following table explains the ResourceManager - GQAM - Data Gbe Ports page
The following table explains the ResourceManager - GQAM - Data Gbe Ports page
parameters.
Note:
Note:
You must be service level to set parameters on a GQAM device.
Not all versions of GQAM software support all parameters.
Parameter
Description
DataIpAddress
Sets/displays the IP address of the data port of the QAM
chassis.
RedundancyMode
Sets/displays the redundancy mode as follows:
Legacy/ASIEnabled - This mode emulates the original
Legacy/ASIEnabled - This mode emulates the original
GQAM functionality with a single GbE port and enabled
ASI ports.
DualWithVIP - This mode enables both GbE ports using
DualWithVIP - This mode enables both GbE ports using
a virtual IP address. A single GbE port is active. If the
active port fails, the alternate GbE port is enabled. The
active GbE port is bound to the virtual IP address. The
effect is that the IP address is constant independent of
which port is enabled.
DualWithoutVIP - This mode enables both GbE ports. A
DualWithoutVIP - This mode enables both GbE ports. A
virtual IP address is not configured. Each GbE port has
its own IP address.