для Cisco DNCS System Release 2.7 3.7 4.2

Скачать
Страница из 36
 
Chapter 2    SR 2.8/3.8/4.3 and Later Sites 
 
 
 
14 
749233 Rev E 
Changing DST Rules 
Quick Path: DNCS Administrative Console > DNCS tab > System Provisioning 
tab > DST > [Select DST Zone ID] > [Change Desired Fields] > Save 
As your system changes or is upgraded, you may need to change a DST rule.  
Notes: 
 
Once you set up a DST rule, that rule remains in effect for each subsequent year; 
you should not need to adjust the rule unless you upgrade your system release 
(SR) software. 
 
Always verify that the correct DST rule is used by the appropriate hubs. Verify 
that the Timezone and DST Zone ID settings are set correctly in the Hub 
window. These settings must be correct because the DNCS uses them to 
broadcast DST data to set-tops in the hubs. 
1  From the DNCS Administrative Console, click the DNCS tab. 
2  Click the System Provisioning tab. 
3  Click DST. The Configure Daylight Saving Time Rules window opens. 
4  Edit the settings as you need.  
Remember: The Broadcast Start Time can begin no more than 30 days before the 
start of the DST. 
5  After entering information into all sections of the Configure Daylight Saving 
Time Rules window, click Save. A window opens and displays the DST data 
update submitted message. 
6  Click OK. The message window closes and the DNCS database is updated with 
your changes.  
7  If you have not already done so, display the Hub window and confirm that the 
correct settings are selected for the Timezone and DST Zone ID fields. If 
necessary, change these settings. (Refer to the DNCS Online Help for your system 
for information about modifying hub timezone settings.) 
8  To change a DST rule for another DST Zone ID, repeat steps 4 to 7. 
9  To close the Configure Daylight Saving Time Rules window, click Exit