Руководство По Установке для Cisco DNCS System Release 2.7 3.7 4.2
Chapter 3 Phase Two - Test New Software
50
78-4003052-01 Rev G
OSM Download for Individual Test DHCTs
The next step in the OSM download process is to use the DNCS to associate software
for each test DHCT.
Assigning the TOC File for Test DHCTs
Complete the following steps to associate software for individual test DHCTs using
the OSM download method.
1 Ping the test DHCTs to make sure that they are connected to the network and set
1 Ping the test DHCTs to make sure that they are connected to the network and set
to two-way mode.
2 Open the Set Up DHCT screen and associate the new code to the DHCT.
3 Click Select next to the S/W Table of Contents field.
4 Select the ver file and click OK.
4 Select the ver file and click OK.
Note: If all of the steps in this process (up to this point) have been executed
correctly, then the .ver file for the new software should be your only choice.
5 Click Save.
6 Repeat steps 1 through 5 for each DHCT that you are testing.
7 Your next step is to download OSM software to the DHCTs. Go to
6 Repeat steps 1 through 5 for each DHCT that you are testing.
7 Your next step is to download OSM software to the DHCTs. Go to
Download
Software to the Individual Test DHCTs (on page 51).