Руководство По Установке для Cisco DNCS System Release 2.7 3.7 4.2
Phase Four Checklist
78-4003052-01 Rev G
79
Phase Four Checklist
Use the checklist in this chapter to check off each task as you complete it. When you
finish this phase, save a copy of the checklist and all of the results from any tests that
you run in the event that the installation process fails during a later phase.
CAUTION:
You must complete each task in this checklist before you can proceed to the
You must complete each task in this checklist before you can proceed to the
next task. Otherwise, you risk a failed installation, which could disrupt
service to your subscribers.
Where necessary, the remaining sections of this chapter provide further detail to
help you complete each task in this checklist.
Installation Checklist
1 Go to
Force an Immediate Download (on page 80) to download software to
DHCTs that did not receive the software in the original download.
2 Run a dhctStatus report using the procedures outlined in the DHCT Status
Reporting and signonCount Utilities User's Guide to determine which DHCTs did
not receive the new software.
If all of the DHCTs received the new software, you have completed these
procedures.
If some DHCTs did not receive the new software, go to step 3.
3 Run the IIH utility, as described in the CoolTools Utilities User's Guide, to reboot
DHCTs with the old software. Wait 24 hours before performing step 4.
4 Twenty-four hours after performing step 3, run a new dhctStatus report. If the
report indicates that there are several DHCTs still using old software, contact
Cisco Services.