Руководство По Установке для Cisco DNCS System Release 2.7 3.7 4.2
78-4011510-01 Rev C
Configure an NTP Server
3-7
Stop and Restart the S99xntpd Process
Introduction
After you change the ntp.conf file, you must stop and restart (bounce) the S99xntpd
process for the system to recognize and implement your changes.
Important: Bouncing the S99xntpd process will not impact the DNCS or subscriber
Important: Bouncing the S99xntpd process will not impact the DNCS or subscriber
cable services.
Bouncing the S99xntpd Process
Complete these steps to bounce the S99xntpd process.
1.
Use the xterm window to log in as root user, if you have not already done so.
2.
Type /etc/rc2.d/S99xntpd stop and press Enter.
Result: The system stops the S99xntpd process and displays the command
Result: The system stops the S99xntpd process and displays the command
prompt.
3.
Type /etc/rc2.d/S99xntpd start and press Enter.
Result: The system restarts the S99xntpd process and displays the command
Result: The system restarts the S99xntpd process and displays the command
prompt. Your next step is to run the Doctor Report as described in the next
section to verify that the connection with the NTP server has been
re-established.
4.
Type exit and press Enter to exit as root user.
5.
Go to Verify and Monitor NTP Server Configuration and Connection, next
in this chapter.