Руководство По Установке для Cisco DNCS System Release 2.7 3.7 4.2
4-6
DBDS System Time Maintenance
78-4011510-01 Rev C
DBDS System Time Synchronization Maintenance,
Continued
9.
If the GPS or the NTP server is not reachable, select one of the following
options:
•
•
If you are using the GPS, check the physical hardware connections
between the DNCS and the GPS. See the Establishing GPS to DNCS
Connectivity procedure in the Install the Digital System Time Kit
section of Chapter 2 for further details.
•
If you are using an NTP server, troubleshoot the communication link
between the DNCS and the NTP server.
10. Use the date command to verify the current system time. Then, go to step 11.
11. Repeat steps 3 through 6. Did you receive an acceptable result?
11. Repeat steps 3 through 6. Did you receive an acceptable result?
•
If yes, go to step 12.
•
If no, contact Cisco Services for assistance.
12. After performing the procedures in this section, did the DNCS time change by
more than 2 minutes?
•
•
If yes, reset the siManager and qamManager processes. Go to Chapter 5,
Reset System Processes for detailed procedures. Then repeat the
procedures in this section.
•
If no, go to step 13.
13. To exit, type q and then press Enter.
14. Did you come here from step 20 of the Establishing GPS to DNCS
14. Did you come here from step 20 of the Establishing GPS to DNCS
Connectivity procedure in the Install the Digital System Time Kit section in
Chapter 2?
•
•
If yes, return to step 21 of that procedure.
•
If no, go to step 15.
15. Go to Verifying Application Server Synchronization, next in this section.