Руководство По Обслуживанию для Cisco Cisco StadiumVision Director
© 2012 Cisco Systems, Inc. All rights reserved.
Page 60 of 103
There are two categories of Display Specs for each type of TV: Basic Info and Serial
Commands. Display specifications for several common TV types are included with
CISCO STADIUMVISION DIRECTOR when installed. If the TV that you are
installing is not listed then refer to the manufacturer’s documentation to obtain the
necessary codes. The TV qualification section describes this in further detail. Once
the codes have been obtained, add a new display specification as described in the
following section.
Commands. Display specifications for several common TV types are included with
CISCO STADIUMVISION DIRECTOR when installed. If the TV that you are
installing is not listed then refer to the manufacturer’s documentation to obtain the
necessary codes. The TV qualification section describes this in further detail. Once
the codes have been obtained, add a new display specification as described in the
following section.
Configuring Display Specifications: Basic Info
In the Cisco StadiumVision Director Control Panel go to Setup > Devices, and
select Display Specifications. On the Basic Info tab, specify the following
information:
select Display Specifications. On the Basic Info tab, specify the following
information:
Figure 43.
Basic Info Screen
• Device Name: This is the name that will appear in the Display Spec drop-down
list when you are adding TV Types to Locations in StadiumVision Director). This
name should be unique and descriptive so you can easily identify the type of TV
to which this applies.
name should be unique and descriptive so you can easily identify the type of TV
to which this applies.
• Make: The TV make or brand name.
• Model: The TV Model to which this Display Specification applies. You can enter
a unique model type, a group of models, or All to indicate that all TVs of this
brand have the same Display Specifications.
brand have the same Display Specifications.
• X and Y coordinates for positioning and scaling (Optional). You should change
these settings only if required for older TVs where graphics need to be fitted
within the visible area. When using a recent 16:9 flat panel TV no positioning or
scaling is generally required.
within the visible area. When using a recent 16:9 flat panel TV no positioning or
scaling is generally required.
These parameters default to (0, 0) for position and (0, 0) for scaling. The
combination of these parameters allows you to position the Flash template
application and stretch or shrink it anywhere on the screen to fit on the TV
screen.
combination of these parameters allows you to position the Flash template
application and stretch or shrink it anywhere on the screen to fit on the TV
screen.
o
Position Parameters: The X Position and Y Position parameters represent
the starting point of the image. If they are not set correctly, the images will