Руководство По Обслуживанию для Cisco Cisco StadiumVision Mobile
© 2012 Cisco Systems, Inc. All rights reserved.
Page 52 of 103
Note: To see the detailed DMP Status, click the Status tab.
Figure 40.
Provisioned DMPs in the Control Panel
Preparing Cisco StadiumVision Director, a DHCP Server &
DMPs for Auto-Registration
DMPs for Auto-Registration
Perform the following steps to prepare Cisco StadiumVision Director, a DHCP
Server and the DMPs for auto-registration and auto-provisioning.
Server and the DMPs for auto-registration and auto-provisioning.
1. Enable auto-registration and auto-provisioning in the Cisco StadiumVision
2. For auto-registration to work, DHCP for the DMPs must be set to “on” under
Cisco StadiumVision Director Configuration. By default DHCP is enabled, but
verify that the setting has not been changed.
verify that the setting has not been changed.
3. Setup the DHCP Server with options that enable the DMP to discover and
section.
4. Verify that the DMPs being deployed are auto-registration capable. This requires
that they are running SE2.2.1 build 1932 or later, or DMS 5.2.2 or later. Both of
these firmware versions have been available long enough that it can be
assumed that all units shipped from the factory are imaged with auto-registration
capable firmware. Units that have been sitting on the shelf at a distributor for an
extended period of time might arrive with an older version that does not support
auto-registration.
these firmware versions have been available long enough that it can be
assumed that all units shipped from the factory are imaged with auto-registration
capable firmware. Units that have been sitting on the shelf at a distributor for an
extended period of time might arrive with an older version that does not support
auto-registration.