Техническая Спецификация для Cisco Prisma II 1310 nm HDTx Transmitters
Data Sheet
© 2001-2003, 2007-2008, 2010, 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 2 of 12
Prisma II Chassis Configuration
Slots 1 through 16, left to right
Slots 1 and 3 are dedicated to power supplies.
Slots 2 and 4 can accommodate any single width Application Module
(i.e., Optical Amplifier, Transmitter, Receiver, etc.).
Slots 5 through 16 can accommodate any Application Module.
Intelligent Communications Interface Module 2 (ICIM2), if used, must be installed in slots 15 and 16.
(Note: An ICIM or ICIM 2 is not required in every chassis.)
Blanks are required in all unused slots of the chassis to maintain proper cooling for all other modules.
High-Density Modules require a separate Host Module.
Prisma II products include some of the industry’s most complete range of high performance optical components.
For more information, please refer to:
Prisma II 1310 nm High-Density Transmitters Data Sheet Part Number 7006768
Prisma II 1 GHz 1550 nm Transmitters Data Sheet Part Number 7009178
Prisma II 1550 nm Optical Amplifiers Data Sheet Part Number 739202
Prisma II Forward Optical Receivers Data Sheet Part Number 7011887
Prisma II Reverse Optical Receivers Data Sheet Part Number 7011888
Prisma II Redundancy Interface Panel Data Sheet Part Number 751713
Ancillary Modules Data Sheet Part Number 739205
BDR Digital Reverse 2:1 Multiplexing System Data Sheet Part Number 744484
BDR Digital Reverse 4:1 Multiplexing System Data Sheet Part Number 746623