Руководство По Установке для Cisco Cisco Prisma II EDR Receiver
2-6
Installation
78-713378-01 Rev C
Connecting the RF Cables to the Chassis
RF Cable Connection Procedure
Important: This procedure assumes the Prisma II Chassis is mounted in a rack.
Follow this procedure to make the RF connections for each module to be installed.
Follow this procedure to make the RF connections for each module to be installed.
1.
At the front/rear of the Prisma II Chassis, locate the RF ports.
Note: RF Ports are located on the front of front access chassis.
2.
Attach an RF cable to the Port A connector (RF output) of the corresponding
slot where the module is to be installed. This is the RF output connection.
3.
Route the RF cable from Port A to the appropriate RF destination.
4.
Connect another RF cable to Port B (RF output) of the slot where the module
is installed. Hand-tighten the connector.
5.
Route the RF cable from Port B to the appropriate RF destination.
6.
If F-connectors are installed, use a 7/16-in. open-end wrench to secure both
cables to the connectors at the chassis.