Руководство По Установке для Cisco Cisco OptoStar II Driver Amplifier

Скачать
Страница из 82
Operating using NMS Software 
This section introduces the procedures to use the OptoStar II network 
management system (OptoStar II NMS) to manage the OptoStar II 1550 nm 
optical amplifier module. 
Before You Begin 
• 
One PC 
• 
A network cable 
• 
OptoStar II NMS software installation package 
System Requirements 
• 
Supported operation system: Windows 7, Windows Server 2008, Windows 
Vista, and Windows Server 2003 
• 
Processor: 400 MHz Pentium or equivalent processor (minimum requirement); 
1 GHz Pentium or equivalent processor (recommended)   
• 
Memory: 512 MB (minimum requirement); 1 GB (recommended)   
• 
Hard drive: 500 MB free space required   
• 
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color, 
32-bit (recommended)   
Start 
1.  Make sure that the fibers of the OptoStar II 1550 nm optical amplifier module 
are connected. 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the 1550 nm optical amplifier module 
will initialize for about 5 seconds, and the ICIM will load for about 25 
seconds. 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
3.  When the device initialization is complete, connect to the Ethernet with the 
RJ-45 connector on the rear panel of the ICIM. Connect the PC to the Ethernet. 
The illustration below shows the connection method.   
 
Continued on next page 
OL-29666-02   
Operation 
3-23