Руководство По Установке для Cisco Cisco OptoStar II 1550nm Transmitter
Console-Module Control Interface, Continued
Setup Parameters
The table below lists the setup parameters of the OptoStar II 1310 nm forward
transmitter module.
transmitter module.
Setup Parameters
Description
Factory Default
Optical Alarm
Threshold
Shows/sets optical alarm upper
limit and lower limit
Lower limit: standard
value -2.2 dB;
Upper limit: standard
Upper limit: standard
value +1.5 dB
Gain Control Mode
Selection
Shows/sets AGC or MGC gain
control mode
AGC mode (MGC
gain setting is 0 dB)
Channel Load
Shows/sets analog channel
number, QAM channel number,
and delta level (dB)
Broadcast RF Input
Port analog channel
number: 59;
QAM channel
QAM channel
number: 50;
Delta level: 6.0 dB
Delta level: 6.0 dB
Laser Status
ON/OFF
Shows/sets laser status:
ON/OFF
Laser Status: ON
Alarm ON/OFF
Shows/sets module alarm
status: ON/OFF
Alarm status: ON
CW/Video Mode
Selection
Shows/sets CW/video mode:
CW/video
Video mode
Continued on next page
3-24
Operation
OL-29664-05