Руководство По Установке для Cisco Cisco OptoStar II Driver Amplifier
Operating using NMS Software, Continued
The table below lists the basic parameters of the OptoStar II optical switch
module.
module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Shows the IP of the node where the module is
located
located
S/N
Shows module serial number
Slot ID
Shows the ID of the slot where the module is
placed
placed
Module Firmware Version
Shows module firmware version
Module Temperature
Shows the current module temperature (°C)
Optical Power Input Information
Optical Input Power in Channel
A/B
A/B
Shows optical input power in Channel A/B
(dBm)
(dBm)
Setup Parameters
The table below lists the setup parameters of the OptoStar II optical switch
module.
module.
Setup Parameters
Description
Factory Default
Optical Signal Input Information
Switching Mode
Selection
Selection
Shows/sets auto/manual
switching mode
switching mode
Auto switching mode
A/B Channel Switch
Shows/sets A/B channel
Channel A
Comment
Comment
You may add applicable
comments as required.
comments as required.
None
OL-29670-02
Operation
3-25