Руководство По Установке для Cisco Cisco OptoStar II Driver Amplifier

Скачать
Страница из 67
 
  Continued on next page 
Operating using ICIM LCD 
This section describes how to use the OptoStar II ICIM LCD to operate the 
OptoStar II forward driver amplifier module.   
Start 
1.  Make sure that the RF cables of the OptoStar II forward driver amplifier 
module are connected.
 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the forward driver amplifier module 
will initialize for about 5 seconds, and the ICIM will load for about 25 
seconds.
 
Note: The system will achieve optimal working condition after one hour’s 
warm-up.
 
The LCD now displays ICIM loading screen as shown below. 
 
3.  When the device initialization is complete, remove the ICIM display and 
begin operation. 
 
 
Continued on next page 
 
 
3-4 
 
Operation 
OL-29667-02