Руководство По Установке для Cisco Cisco OptoStar II 1550nm Transmitter
Operating using NMS Software
This section introduces the procedures to use the OptoStar II network
management system (OptoStar II NMS) to manage the OptoStar II intelligent
communications interface module.
management system (OptoStar II NMS) to manage the OptoStar II intelligent
communications interface module.
Before You Begin
•
One PC
•
A network cable
•
OptoStar II NMS software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Server 2008, Windows
Vista, and Windows Server 2003
Vista, and Windows Server 2003
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 512 MB (minimum requirement); 1 GB (recommended)
•
Hard drive: 500 MB free space
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the fiber and RF cables of relevant modules of the OptoStar II
Platform are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and other modules will initialize for
about 5 seconds, and the ICIM will load for about 25 seconds.
about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
warm-up.
Continued on next page
3-18
Operation
OL-29660-03