Руководство По Установке для Cisco Cisco OptoStar II Driver Amplifier
Operating using ICIM LCD, Continued
Sub-menu 3 -- Trap Destination
The illustration below shows sub-menu 3 of the OptoStar II intelligent
communications interface module -Trap Destination.
communications interface module -Trap Destination.
Default trap destination is only set to: 192. 168. 000. 100. The cursor stays on
Enabled by default.
Enabled by default.
•
To change or set other trap destination:
1. Press ▲▼ to select address;
2. Press ► button to move the cursor in the first field of the IP address;
3. Press SET button to start the configuration;
4. Press SET button to save the configuration.
5. Press ◄ to move the cursor to column Disabled, and press SET button to
2. Press ► button to move the cursor in the first field of the IP address;
3. Press SET button to start the configuration;
4. Press SET button to save the configuration.
5. Press ◄ to move the cursor to column Disabled, and press SET button to
change Disabled to Enabled, and “” changed to “”.
•
To cancel a trap destination: reverse operation
1. Press SET button to save the configuration.
2. To set more trap destination, repeat the above steps.
2. To set more trap destination, repeat the above steps.
Continued on next page
OL-29660-03
Operation
3-9