Руководство По Установке для Cisco Cisco OptoStar II Driver Amplifier

Скачать
Страница из 64
Operating using NMS Software 
This section introduces the procedures to use the OptoStar II network 
management system (OptoStar II NMS) to manage the OptoStar II RF switch 
module. 
Before You Begin 
• 
One PC 
• 
A network cable 
• 
OptoStar II NMS software installation package 
System Requirements 
• 
Supported operation system: Windows 7, Windows Server 2008, Windows 
Vista, and Windows Server 2003 
• 
Processor: 400 MHz Pentium or equivalent processor (minimum requirement); 
1 GHz Pentium or equivalent processor (recommended) 
• 
Memory: 512 MB (minimum requirement); 1 GB (recommended) 
• 
Hard drive: 500 MB free space required 
• 
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color, 
32-bit (recommended) 
Start 
1.  Make sure that the RF cables of the OptoStar II RF switch module have been 
connected. 
 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the RF switch module will initialize 
for about 5 seconds, and the ICIM will load for about 25 seconds.
 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
 
Continued on next page 
 
 
 
OL-29669-02 
Operation 
3-21