Листовка для Cisco Cisco TelePresence MX700

Cisco TelePresence Endpoints and Cisco Unified Communications Manager 

Quick Reference Guide

D14996.02 Administering TC6.1 Endpoints on CUCM 9.1.1, April 2013. 

www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved. 

27

Verifying the endpoint registration

After having provisioned the endpoint to CUCM you should 

verify that the registration was successful. You can do this 

by making a call or by checking the system information.

Making a call

Make a call from the TelePresence endpoint to see if the 

registration was successful.

Use the interface of your choice:

•  The web interface
•  The Touch controller or remote control
•  The command line

Checking the system information  

When checking the system information, the 

SIP Status 

should show Registered and the 

SIP Proxy should display the 

address of the CUCM.

Using the web interface
Navigate to Home > System Information and see the SIP 

section.

Using the Touch controller
Tap   (Settings) > System Information on the Touch and see 

the SIP section.

Using the remote control
Navigate to Home > Settings > System Information and see 

the SIP section.

Using the command line interface
Open a command line interface (e.g. PuTTY), log in to the 

endpoint (codec), and run the following API commands:

xStatus SIP Profile 1 Registration 1 Status 
xStatus SIP Proxy 1 Address
or:

 xStatus SIP - to see a complete overview.

Contents

Introduction

CUCM configuration

Endpoint configuration

About passwords

Appendices

Endpoint configuration