Руководство Пользователя для Cisco Cisco Content Security Management Appliance M160
13-47
Cisco IronPort AsyncOS 8.0 for Security Management User Guide
Chapter 13 Common Administrative Tasks
<listeners></listeners>
Warning
When uploading or pasting subsections of a configuration file, you can disconnect yourself from the
GUI or CLI and destroy large amounts of configuration data. Do not disable services with this
command if you are not able to reconnect to the appliance using another protocol, the Serial
interface, or the default settings on the Management port. Also, do not use this command if you are
unsure of the exact configuration syntax as defined by the DTD. Always back up the configuration data
before loading a new configuration file.
GUI or CLI and destroy large amounts of configuration data. Do not disable services with this
command if you are not able to reconnect to the appliance using another protocol, the Serial
interface, or the default settings on the Management port. Also, do not use this command if you are
unsure of the exact configuration syntax as defined by the DTD. Always back up the configuration data
before loading a new configuration file.
Note About Loading Passwords for Log Subscriptions
If you attempt to load a configuration file that contains a log subscription that requires a password (for
example, one that will use FTP push), the
example, one that will use FTP push), the
loadconfig
command does not warn you about the missing
password. The FTP push fails and alerts are generated until you configure the correct password using the
logconfig
command.
Note About Character Set Encoding
The “encoding” attribute of the XML configuration file must be “
ISO-8859-1
” regardless of the
character set you may be using to manipulate the file offline. The encoding attribute is specified in the
file whenever you issue the
file whenever you issue the
showconfig
,
saveconfig
, or
mailconfig
command:
<?xml version="1.0" encoding="ISO-8859-1"?>
Currently, only configuration files with this encoding can be loaded.
Resetting the Current Configuration
Resetting the current configuration causes your Cisco IronPort appliance to revert back to the original
factory defaults. Save your configuration prior to resetting it. Resetting the configuration via the Reset
button in the GUI is not supported in a clustering environment.
factory defaults. Save your configuration prior to resetting it. Resetting the configuration via the Reset
button in the GUI is not supported in a clustering environment.
Figure 13-14
Resetting the Configuration File
See
CLI Commands for Configuration Files
The following commands enable you to manipulate the configuration files:
•
showconfig
•
mailconfig
•
saveconfig
•
loadconfig
•
resetconfig (see