Руководство По Установке для Cisco Cisco Email Security Appliance C170
5
5
Install the Appliance in a Rack
Install the Cisco C190 Email Security Appliance using the rails
supplied. For information about these installation options, see
the Cisco x90 Series Content Security Appliances Installation
and Maintenance Guide.
supplied. For information about these installation options, see
the Cisco x90 Series Content Security Appliances Installation
and Maintenance Guide.
Appliance Placement in a Rack
•
Ambient Temperature—To prevent the appliance from
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
•
Air Flow—Be sure that there is adequate air flow around
the appliance.
the appliance.
•
Mechanical Loading—Be sure that the appliance is level
and stable to avoid any hazardous conditions.
and stable to avoid any hazardous conditions.
6
Plug In the Appliance
Plug the female end of the power cable into the power supply on
the back panel of the appliance. Plug the male end into an
electrical outlet.
the back panel of the appliance. Plug the male end into an
electrical outlet.
7
Temporarily Change Your IP
Address for Remotes Access
To remotely configure the Cisco C190 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco C190, without changing the IP address. If
you use the serial console, proceed to section 8 below.
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco C190, without changing the IP address. If
you use the serial console, proceed to section 8 below.
Note
Make a note of your current IP configuration settings
because you will need to revert to these settings after
you finish the configuration.
because you will need to revert to these settings after
you finish the configuration.