Руководство По Установке для Cisco Headend System Release 2.7
Restart Utilities
4036043 Rev B
71
Restart Utilities
Restart the dhctStatus Utility
The dhctStatus Utility usually runs from cron and will start at its scheduled time.
Restarting the signonCount Utility
If the signonCount utility was running prior to the upgrade, follow these steps to
restart the utility. If you do not want to start the signonCount utility at this time,
skip this procedure and go to the next procedure in this chapter.
1 Type signonCount and press Enter. The signonCount process starts and begins
restart the utility. If you do not want to start the signonCount utility at this time,
skip this procedure and go to the next procedure in this chapter.
1 Type signonCount and press Enter. The signonCount process starts and begins
displaying settop sign-on status.
2 Press the Ctrl and C keys simultaneously to stop the terminal output.
3 Type
3 Type
tail -f /dvs/dncs/tmp/signonCount.out
and press Enter to
monitor the signonCount utility status. The terminal displays the last 10 lines in
the output file, as well as any new entries made to the output file.
the output file, as well as any new entries made to the output file.
4 Press the Ctrl and C keys simultaneously to terminate the tail process.
Restart the cmd2000 Utility
1 To restart the cmd2000 utility, type the following command and then press
Enter:
/dvs/resapp/Tools cmd2000 -log -listen &
2 To confirm that the cmd2000 utility is running, type the following command and
press Enter:
ps -ef | grep cmd2000